SWN March 24, 2020

COVID-19 has bitten hard, with NZ going in to lock-down tomorrow. So tonight’s Sim Work Night was pretty quiet. After spending the afternoon converting the ManCave into a temporary work office, I decided that I still needed to do something on my sim. So tonight I did some messing around with displays in the Skyhawk, and a cool tool for ‘storing’ and ‘restoring’ panel positions. This means that I can fine tune the positions of all of my undocked panels, an recall them whenever I need.
This application has changed my plans for how I will “build” the virtual panel for the sim. Instead of building a single panel, with all my gauges on it, I will make individual panels for each gauge which I can then move and size to fit the panel. Then I can use these cool apps to store the positions.
I also *temporarily* pointed the projector lower to align with the HUD. This is until I design and build new legs to bring the height up to where I now want it.

Quick and dirty, but shows the capabilities of the apps!

Leave a Reply

Your email address will not be published. Required fields are marked *